20-01-13, 03:38 AM
(19-01-13, 08:01 PM)unfazed link Wrote: Before you start replacing anything try spraying the area where the lever pushes/touches the master cylinder piston with WD40 including the rubber boot around the master cylinder piston. If that solves the problem then remove the lever and grease the pivot and the point where the lever pushes the piston of the master cylinder.
I didn't know your "judder" was on the brake lever while stationary, so that rules out my Disc suggestion. But on the plus side, I had your problem a month ago and sorted it the way "unfazed" suggested above with WD40 up into the master cylinder piston where the lever comes in contact.