Fazer Owners Club - Unofficial › Bikes, Hints'n'Tips › FZS600 Fazer v
Changing the end can

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Changing the end can
Lawrence Offline
WSB Pack Hound
*****
Posts: 830
Threads: 22
Joined: Feb 2012
View Submissions | Download History
#16
03-01-13, 10:34 PM
(03-01-13, 06:34 PM)Mark YPVS link Wrote: its goes well up to about 7500 Rpm and then not a lot happens :'(
I tend to find it doesn't do that much up to about 8k and then goes mental, get those restrictors out Big Grin
Find
Reply


Messages In This Thread
Changing the end can - by xlewisbdx - 02-01-13, 04:07 PM
Re: Changing the end can - by markbubble - 02-01-13, 04:17 PM
Re: Changing the end can - by His Dudeness - 02-01-13, 05:59 PM
Re: Changing the end can - by markbubble - 02-01-13, 06:55 PM
Re: Changing the end can - by darrsi - 03-01-13, 01:33 AM
Re: Changing the end can - by xlewisbdx - 03-01-13, 02:10 AM
Re: Changing the end can - by Skippernick - 03-01-13, 08:42 AM
Re: Changing the end can - by markbubble - 03-01-13, 02:07 PM
Re: Changing the end can - by darrsi - 03-01-13, 02:12 PM
Re: Changing the end can - by noggythenog - 03-01-13, 03:21 PM
Re: Changing the end can - by bwizz - 03-01-13, 03:51 PM
Re: Changing the end can - by xlewisbdx - 03-01-13, 05:37 PM
Re: Changing the end can - by His Dudeness - 03-01-13, 06:14 PM
Re: Changing the end can - by Mark YPVS - 03-01-13, 06:34 PM
Re: Changing the end can - by arch33angel - 03-01-13, 08:37 PM
Re: Changing the end can - by Lawrence - 03-01-13, 10:34 PM
Re: Changing the end can - by His Dudeness - 03-01-13, 11:41 PM
Re: Changing the end can - by arch33angel - 04-01-13, 12:47 AM
Re: Changing the end can - by His Dudeness - 04-01-13, 01:38 AM
Re: Changing the end can - by stevierst - 04-01-13, 10:20 AM
Re: Changing the end can - by darrsi - 04-01-13, 10:28 AM
Re: Changing the end can - by arch33angel - 04-01-13, 10:29 AM
Re: Changing the end can - by Skippernick - 04-01-13, 08:40 PM
Re: Changing the end can - by stevierst - 04-01-13, 09:17 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)