Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Changing the end can
#14
Hi,
My Fazer is restricted (how i brought it) i thought the first thing i would do would be to get the resrticters out (last bike i had was an R1 for 7 years) when i rode the Fazer it had lots of low/ mid range that i still havnt unrestricted it :eek
However mine has the Yamaha 33bhp kit fitted which  has different carb needles and stiffer throttle springs not the exhaust type 33 bhp kit, its goes well up to about 7500 Rpm and then not a lot happens :'(
when i fitted the Micron race end can (had Motad Nexxus front piped allready fitted Big Grin ) it reved quicker.
If your localish (Heathrow) we can go out for a ride and compare side by side??
Mark
Reply


Messages In This Thread
Changing the end can - by xlewisbdx - 02-01-13, 04:07 PM
Re: Changing the end can - by markbubble - 02-01-13, 04:17 PM
Re: Changing the end can - by His Dudeness - 02-01-13, 05:59 PM
Re: Changing the end can - by markbubble - 02-01-13, 06:55 PM
Re: Changing the end can - by darrsi - 03-01-13, 01:33 AM
Re: Changing the end can - by xlewisbdx - 03-01-13, 02:10 AM
Re: Changing the end can - by Skippernick - 03-01-13, 08:42 AM
Re: Changing the end can - by markbubble - 03-01-13, 02:07 PM
Re: Changing the end can - by darrsi - 03-01-13, 02:12 PM
Re: Changing the end can - by noggythenog - 03-01-13, 03:21 PM
Re: Changing the end can - by bwizz - 03-01-13, 03:51 PM
Re: Changing the end can - by xlewisbdx - 03-01-13, 05:37 PM
Re: Changing the end can - by His Dudeness - 03-01-13, 06:14 PM
Re: Changing the end can - by Mark YPVS - 03-01-13, 06:34 PM
Re: Changing the end can - by arch33angel - 03-01-13, 08:37 PM
Re: Changing the end can - by Lawrence - 03-01-13, 10:34 PM
Re: Changing the end can - by His Dudeness - 03-01-13, 11:41 PM
Re: Changing the end can - by arch33angel - 04-01-13, 12:47 AM
Re: Changing the end can - by His Dudeness - 04-01-13, 01:38 AM
Re: Changing the end can - by stevierst - 04-01-13, 10:20 AM
Re: Changing the end can - by darrsi - 04-01-13, 10:28 AM
Re: Changing the end can - by arch33angel - 04-01-13, 10:29 AM
Re: Changing the end can - by Skippernick - 04-01-13, 08:40 PM
Re: Changing the end can - by stevierst - 04-01-13, 09:17 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)