Fazer Owners Club - Unofficial › Bikes, Hints'n'Tips › FZS600 Fazer v
Changing the end can

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Changing the end can
markbubble Offline
Club Racer
****
Posts: 315
Threads: 22
Joined: Jun 2012
View Submissions | Download History
#4
02-01-13, 06:55 PM
there is a gauze type gasket fitted between the header(or manifold depending on what you want to call them)these are specific to the bike(might fit other bikes)so not something you can get from halfrauds etc you could maybe use exhaust paste etc instead
Find
Reply


Messages In This Thread
Changing the end can - by xlewisbdx - 02-01-13, 04:07 PM
Re: Changing the end can - by markbubble - 02-01-13, 04:17 PM
Re: Changing the end can - by His Dudeness - 02-01-13, 05:59 PM
Re: Changing the end can - by markbubble - 02-01-13, 06:55 PM
Re: Changing the end can - by darrsi - 03-01-13, 01:33 AM
Re: Changing the end can - by xlewisbdx - 03-01-13, 02:10 AM
Re: Changing the end can - by Skippernick - 03-01-13, 08:42 AM
Re: Changing the end can - by markbubble - 03-01-13, 02:07 PM
Re: Changing the end can - by darrsi - 03-01-13, 02:12 PM
Re: Changing the end can - by noggythenog - 03-01-13, 03:21 PM
Re: Changing the end can - by bwizz - 03-01-13, 03:51 PM
Re: Changing the end can - by xlewisbdx - 03-01-13, 05:37 PM
Re: Changing the end can - by His Dudeness - 03-01-13, 06:14 PM
Re: Changing the end can - by Mark YPVS - 03-01-13, 06:34 PM
Re: Changing the end can - by arch33angel - 03-01-13, 08:37 PM
Re: Changing the end can - by Lawrence - 03-01-13, 10:34 PM
Re: Changing the end can - by His Dudeness - 03-01-13, 11:41 PM
Re: Changing the end can - by arch33angel - 04-01-13, 12:47 AM
Re: Changing the end can - by His Dudeness - 04-01-13, 01:38 AM
Re: Changing the end can - by stevierst - 04-01-13, 10:20 AM
Re: Changing the end can - by darrsi - 04-01-13, 10:28 AM
Re: Changing the end can - by arch33angel - 04-01-13, 10:29 AM
Re: Changing the end can - by Skippernick - 04-01-13, 08:40 PM
Re: Changing the end can - by stevierst - 04-01-13, 09:17 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)