28-11-12, 09:32 PM
Good choice. The pilot light current is very small so I can't see it being a problem. It's what I did.
In case you don't know, the relay blade terminals are 6.3mm. So that's the size of blade connectors you want. I'm always a sucker for that sort of thing when I see an interesting box of bits in Aldi or Lidl.
I tend to favour soldering the wires into the connectors, but plenty just use the crimping pliers to secure the wire without a problem.
I would also get some shrink wrap, as it make a good need job of insulating the terminals and only needs a hot air gun or an air drier for the heat to make it shrink.
Good news and bad news about the bike I did this mod on. Bad news is it blew over the other week when we were parked up and damaged the fairing. The good news is the fairing is now off the bike for a bit of repairing so when I next go to my brothers I can have a good look at the wiring etc. I'll report back if I see anything we have missed. Must remember to take my camera
.
In case you don't know, the relay blade terminals are 6.3mm. So that's the size of blade connectors you want. I'm always a sucker for that sort of thing when I see an interesting box of bits in Aldi or Lidl.
I tend to favour soldering the wires into the connectors, but plenty just use the crimping pliers to secure the wire without a problem.
I would also get some shrink wrap, as it make a good need job of insulating the terminals and only needs a hot air gun or an air drier for the heat to make it shrink.
Good news and bad news about the bike I did this mod on. Bad news is it blew over the other week when we were parked up and damaged the fairing. The good news is the fairing is now off the bike for a bit of repairing so when I next go to my brothers I can have a good look at the wiring etc. I'll report back if I see anything we have missed. Must remember to take my camera
.