15-11-12, 10:50 PM
Check the punch mark on the shaft lines up with slot in the gear change bracket on the shaft.
The linkage can be adjusted by turning the bar between the shaft and the gear lever.
Loosen the 10mm nuts (rear one is left hand thread normal tightening direction is loosening) and turn the bar to adjust the lever up or down. When you think it is the correct position for you tighten the nuts and take it for a spin.
This is a trial and error job and may take a few trys to get it right.
The linkage can be adjusted by turning the bar between the shaft and the gear lever.
Loosen the 10mm nuts (rear one is left hand thread normal tightening direction is loosening) and turn the bar to adjust the lever up or down. When you think it is the correct position for you tighten the nuts and take it for a spin.
This is a trial and error job and may take a few trys to get it right.