13-11-12, 01:23 AM
hadta fit my old oxford heated grips and repair a bodge so thought id widen the bars a tad whilst i was at it to seeme through until i decide whether to fit 758s or not.
bodge was a previous owner had snapped off the locating lug in the throttle, and used emery tape clamped in to stop it twisting, though this was moving. so first job was to drill out switch body, turn down a delrin plug, drill switch body, glue in plug, then drill out centre and insert other end of drill and cut off inside to make belt and braces repair.
bodge was a previous owner had snapped off the locating lug in the throttle, and used emery tape clamped in to stop it twisting, though this was moving. so first job was to drill out switch body, turn down a delrin plug, drill switch body, glue in plug, then drill out centre and insert other end of drill and cut off inside to make belt and braces repair.