05-11-12, 08:31 AM
As some one said earlier in the thread heating is due to increased resistance or load if the bulbs are standard and in good order I would suspect a poor conection - Its a simple enough circuit so I would check and clean the conections and put in a new fuse.
You can never rule out the PO factor ( previous owner) - my wiring was getting real hot when on full beam - on inspection the main beam on one bulb had a wire soldered on it linking it to the un used dipped fillament - way too much load - again strangly didnt pop a fuse but the bulb connectors started to melt!
You can never rule out the PO factor ( previous owner) - my wiring was getting real hot when on full beam - on inspection the main beam on one bulb had a wire soldered on it linking it to the un used dipped fillament - way too much load - again strangly didnt pop a fuse but the bulb connectors started to melt!
"Don't Die with Fun in the Bank!"