19-09-12, 07:13 PM
Yes Strifae is correct, I fitted one and all I had to do was file down a part of the 600 mount by about 3 to 4 mm to get a little clearance to get it to fit only other thing is the brake pipe needs to be tightened away from the stop to preven kinking. I put a small nut between the banjo and the stop to allow the correct torque to be set on the banjo bolt and removed it after all was installed/ Use new Copper washers. Not only does it operate much better it looks better also as front and rear match. Just remember to order Fazer 1000 pads when renewing them.