17-09-12, 12:28 PM
Sometimes when pulling off I can hear a little clunk from the bike.
Wheel / bearing feels OK, SLIGHT wear in swingarm bearing in an up and down motion I noticed as I loosened the axle nut prior to chain tightening.
Bike has only done 20k, so I'm a bit unsure what it is, as I did think about cush drive in passing, but that's not likely to cause a clunk is it?
any ideas / past experience?
Wheel / bearing feels OK, SLIGHT wear in swingarm bearing in an up and down motion I noticed as I loosened the axle nut prior to chain tightening.
Bike has only done 20k, so I'm a bit unsure what it is, as I did think about cush drive in passing, but that's not likely to cause a clunk is it?
any ideas / past experience?