17-08-12, 11:55 AM
(17-08-12, 11:40 AM)red98 link Wrote:ive cut a couple of lenghts of 16mm od steel tubing to reduce the size of my compression tool.ive also cut a slot length ways so i can remove the collets....ive cut about a quarter out as dont want to weaken the tube too much....its going to be a struggle getting the collets out through such a small opening but i`ll give it a go..............if i remember right?....we did similar but used a trolley jack handle!!! ...the slot that lowers the jack was spot on for coletts
