Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Gear box shaft replacement
#9
The tab is near useless, ask him what he torqued it to. If he went by Haynes or an old book then it might not be enough. Old was 70 NM. Later updated to 90. Even that's no guarantee. Bit of thread lock, wedge up two sides of washer if not done so already and regular checks. It's a 5 minute job to get cover off and have a peek.
Also listen out for the jingle jangle of the loose washer when it goes. It will sound like a key rattling off a 2 bob in yer pocket constantly. Left pocket obviously
Smell ones mother. Yaas!
Reply


Messages In This Thread
Gear box shaft replacement - by NotAnotherHill - 22-07-12, 01:04 PM
Re: Gear box shaft replacement - by darrsi - 22-07-12, 01:33 PM
Re: Gear box shaft replacement - by Fazerider - 22-07-12, 02:55 PM
Re: Gear box shaft replacement - by Fazerider - 22-07-12, 05:22 PM
Re: Gear box shaft replacement - by Tiberius Onklevaart - 25-07-12, 09:56 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)