|
Nut size?
|
19-06-12, 09:34 AM
(19-06-12, 01:16 AM)darrsi link Wrote: Had my sprocket done a couple of years ago, took my mechanic 45 minutes to heat it up and eventually remove the older size nut, it was virtually welded on. Rather than applying heat in the vicinity of an oil seal another option is to drill the edge of the nut from the end face and split it. Being careful not to damage the shaft of course. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Nut size? - by NotAnotherHill - 12-06-12, 07:33 PM
Re: Nut size? - by darrsi - 12-06-12, 09:02 PM
Re: Nut size? - by limax2 - 12-06-12, 09:09 PM
Re: Nut size? - by daveph - 15-06-12, 05:10 AM
Re: Nut size? - by NotAnotherHill - 17-06-12, 06:20 PM
Re: Nut size? - by ponkster - 17-06-12, 06:28 PM
Re: Nut size? - by NotAnotherHill - 17-06-12, 06:41 PM
Re: Nut size? - by limax2 - 18-06-12, 11:34 PM
Re: Nut size? - by darrsi - 19-06-12, 01:16 AM
Re: Nut size? - by limax2 - 19-06-12, 09:34 AM
|
