31-05-12, 09:08 PM
ok....this might sound a bit silly.....have you disconnected the two breather tubes on the bottom of the tank ?
once you have removed the front bolt just slacken the rear one to allow it to move,lift the tank to about 20/30 degrees and this will give you enough room to release the breather tubes you can then lift the tank a bit more and then disconnect the wireing for the petrol gauge,tank should go to 90 degrees but as already said not when the tank is full
once you have removed the front bolt just slacken the rear one to allow it to move,lift the tank to about 20/30 degrees and this will give you enough room to release the breather tubes you can then lift the tank a bit more and then disconnect the wireing for the petrol gauge,tank should go to 90 degrees but as already said not when the tank is full
One, is never going to be enough.....