stainless downpipes

[solorider]

Oh yes, good tip, I did the same thing with copper grease I think.

Where did you buy those ss nuts? Wouldn't mind some as they are no doubt more resistant to corrosion than the oems.

for my thou i fitted cap head nuts,that way my studs wont rust where the thread shows through the nut,i got mine off ebay,here is mine,i also fitted locking washers as well


but as mentioned somewhere check the torque of the nuts after a week or two,i have just checked mine and none of them were tight despite them all being torqued up,in my case it was the studs that were the culprits as i fitted a full set of studs and despite using a proper stud tool they still came loose