04-04-12, 11:57 AM
Heat the existing disc bolts beforehand with a butane torch to soften the Loctite, then whack 'em immediately with a good fitting impact driver & they should loosen off a fraction without rounding. As mentioned, use a torque wrench to re-set the disc bolts to correct spec
Pads easy enough but check that all your brake pistons are freely moving otherwise uneven wear & dragging-on brakes may mean another replacement set in the near future.
Pads easy enough but check that all your brake pistons are freely moving otherwise uneven wear & dragging-on brakes may mean another replacement set in the near future.