02-04-12, 01:31 PM
Hi all, had a nice ride out yesterday but noticed my bite point was near enough at the end of travel when letting it out. i adjusted on the engine side and then the cable but hasn't helped much.
I did notice the plain plates are rather close but unsure what the gap should be.
also when you depress the clutch lever (with engine off) and look through the oil fill hole the 1st set of plain plates and friction plates separate from the others.. is this correct? any other foccers able to check theres and let me know if theirs does the same?
the clutch does not feel as though it slips but i am worried because i am doing a tour of Ireland in May so i want it right before i go.
Many thanks,
I did notice the plain plates are rather close but unsure what the gap should be.
also when you depress the clutch lever (with engine off) and look through the oil fill hole the 1st set of plain plates and friction plates separate from the others.. is this correct? any other foccers able to check theres and let me know if theirs does the same?
the clutch does not feel as though it slips but i am worried because i am doing a tour of Ireland in May so i want it right before i go.
Many thanks,
Lord,
Grant me the WD-40 to move those things that are stuck, the Duck tape to fasten those things that are loose, And the wisdom to know the difference.
Amen
Grant me the WD-40 to move those things that are stuck, the Duck tape to fasten those things that are loose, And the wisdom to know the difference.
Amen