29-03-12, 09:54 AM
As I recall there isn't a hex screw as such, the bar end is solid with a hex indent to facilitate screwing in/out.
So if the bar end is a right off already you could attempt removing it by just trying to unscrew the whole bar end - mole grips etc.
If this fails then hacksawing off the end and drilling out what remains is possibly the next best approach.
So if the bar end is a right off already you could attempt removing it by just trying to unscrew the whole bar end - mole grips etc.
If this fails then hacksawing off the end and drilling out what remains is possibly the next best approach.
....----//// Life is not a rehearsal \\\\----....