28-03-12, 07:50 PM
The old rear roller bearing will need to be cut out using a dremel or die grinder. New one needs to be pressed in or drawn/pulled in with
I had to do the same (cut the outer casing with a dremmel) it was a bitch . I too thought that you may be able to drift it out from the back but the wheel shoulder is almost flush with the inside of the race & does,nt give you enough surface area to get a drift on
I had to do the same (cut the outer casing with a dremmel) it was a bitch . I too thought that you may be able to drift it out from the back but the wheel shoulder is almost flush with the inside of the race & does,nt give you enough surface area to get a drift on