17-03-12, 05:01 PM
just got back from yam dealer,got four ngk caps and 2 meters of ht lead for £20.01,£2.50 per metre for the lead,3.75 each for the caps.enquired about the price of shims and was supprised :eek at between £4/£5 each,if you needed to replace the whole lot that would be close to £80,can you get pattern parts?
had a word with the mechanic while i was down there,he said not to worry about the inlet clearences but it might be worth doing the exhaust,but if it was his bike he wouldnt bother.
i asked about the stuttering and he said exactly as mentioned on here by FAZERIDER and GNASHER ,my thanks to you both
......CARBS....in particular emulsion tube,main jets and diaphram,either blocked or split...could also be moisture in the float bowls,which could be your problem CLAYT74 
.
iam going to look for pattern shims and just do the exhaust valves,and then remove the carbs and give them a good clean and check over
had a word with the mechanic while i was down there,he said not to worry about the inlet clearences but it might be worth doing the exhaust,but if it was his bike he wouldnt bother.
i asked about the stuttering and he said exactly as mentioned on here by FAZERIDER and GNASHER ,my thanks to you both
......CARBS....in particular emulsion tube,main jets and diaphram,either blocked or split...could also be moisture in the float bowls,which could be your problem CLAYT74 .iam going to look for pattern shims and just do the exhaust valves,and then remove the carbs and give them a good clean and check over
One, is never going to be enough.....