LED handguard lights

[phil on a fazer]

Hi Phil,


I run my heated grips, heated jacket and the LEDs off the fuzeblock.


I will post up some photos of that as it's a straight forward install, i know a lot of people aren't too sure about electrics but it is straight forward. 


The fuzeblock is a well made bit of kit and as it's individually fused it gives goo protection for each circuit you connect.  You can also configure each feed to be either permanent or switched.


I'm going to wire in Red LED's into the topbox this weekend so will post some more pics up of the install and also how you can cut the LED strips to the size you want for install.

that would be great, tar. With some pics i could be tempted to have a go, I'm fine with basic mechanics but electrics i find a little off putting.

BikeVis sell "red LED bullets" that are for brake lights, i was thinking about these as well as Acrebis LED handguards so i think the fuzeblock maybe the way to go. Would put the extra brake LEDS some near the top of the number plate, maybe where the plastic curves round???

Did you get your Fuzeblock from the website you posted?

Cheers