13-02-12, 01:28 PM
Firstly, sorry, I did not read it right. I thought you wanted to go 5mm forward, not 50mm!
I was going to go either forward or down, but decided that down and back felt best (most open) for the knees. I also tried the longer adjusters and they were just too long without modifying the actual levers (which I guess is what you are asking for!)
I seem to remember that, with consideration of the rubber bit and thinner pegs etc, the overall drop was just over 1".
Cannot remember having any problems with the pipe and the pedal is as low as it can go on the thread (or high on the thread to lower the end?), so I guess either the pedal goes beside the pipe or stops above it. Given the estimated 1" drop in foot pegs, I guess I dropped the pedal 1" too.
I was going to go either forward or down, but decided that down and back felt best (most open) for the knees. I also tried the longer adjusters and they were just too long without modifying the actual levers (which I guess is what you are asking for!)
I seem to remember that, with consideration of the rubber bit and thinner pegs etc, the overall drop was just over 1".
(13-02-12, 12:48 PM)TrukkoMan link Wrote: On Ghoti, thanks for getting cold to take the pix. Very helpful. On the brake side, did you get much drop and still miss the pipe?
Cannot remember having any problems with the pipe and the pedal is as low as it can go on the thread (or high on the thread to lower the end?), so I guess either the pedal goes beside the pipe or stops above it. Given the estimated 1" drop in foot pegs, I guess I dropped the pedal 1" too.