Hi.. the bolts that go thro the crash bung are:
top bolt m10 = 55nm (the yam service manual states 33nm for this bolt as well but the link below states 55nm)
bottom m8 = 33nm
the bolt that goes thro the cradle and thro engine block is m10 and should be = 55nm.
This link may help in the future http://www.cartestsoftware.com/fz1/index.html
Dave
top bolt m10 = 55nm (the yam service manual states 33nm for this bolt as well but the link below states 55nm)
bottom m8 = 33nm
the bolt that goes thro the cradle and thro engine block is m10 and should be = 55nm.
This link may help in the future http://www.cartestsoftware.com/fz1/index.html
Dave