05-02-12, 06:26 PM
So with painting the rad its a case of rubbing down the flaky/bobbled bits but leaving the areas that are o.k? then prime the rubbed down area and leave to dry. Then a few light coats a black spray all over (the sides I'm on about, not the fins) So do you need to cure it?
i guess painting the frame is the same....bit more awkward though. Could do with primer that i can use a small brush to paint on the rusty areas (which i will rub down first). Don't fancy using a spray can, even with bits taped up it could still go horribly wrong.
might be a trip to Halfords
, as i need to get a move on getting this done.
i guess painting the frame is the same....bit more awkward though. Could do with primer that i can use a small brush to paint on the rusty areas (which i will rub down first). Don't fancy using a spray can, even with bits taped up it could still go horribly wrong.
might be a trip to Halfords
, as i need to get a move on getting this done.