21-01-12, 12:01 PM
My Gen1 side stand seems too short. The bike leans over at a right jaunty angle. It is stable enough but a worry to put down even on flat ground.
I have measured it thusways: With the stand up I used a tape rule and measured along the center of the stem from the center of the mounting bolt to the flat of the sole. The figure I came up with was 245mm.
Is anyone prepared to get down on the floor and measure theirs for me
? Is it likely that this is non standard? Are there any longer ones that I can fit?
I have measured it thusways: With the stand up I used a tape rule and measured along the center of the stem from the center of the mounting bolt to the flat of the sole. The figure I came up with was 245mm.
Is anyone prepared to get down on the floor and measure theirs for me
? Is it likely that this is non standard? Are there any longer ones that I can fit?