11-12-11, 07:48 PM
replacement sleeve? the raplcement rivets and bands are cheap enough (or were when i bought them a few years ago)
alternatively if the can was disassembled (which it would have to be to be cut down) it looks like the type of dent that will push out and then the inlet cap could be turned 180 degrees... i don't think it's quite the disaster it might appear at first...
i forgot to put the side stnd down once and rolled my rear paddock stand out from under my r6. i dived under the bike and took it upon myself to cushion it from the wall and garage floor. the next few moments didn't see me thanking myself for my decision but once missus had somewhat rescued me (after some shouting for help) and healing started i was pleased that i had done it. the bike was unmarked, i hurt in a few places. i'm not sure i should have shared that story....
is it clean enough?