27-10-11, 09:01 PM
(25-10-11, 06:38 PM)Kenny Dave link Wrote: You can take one side out, clean the stuff in there, put them back in and then pop the other side and clean under there.
Or, if you use clamps to get both sides of the piston near the middle, then you can usually get one side out then just jiggle the other side with your fingers to get all out at once. If they are very stiff then that won't work.
Excuse me for being thick but what are these? they look like some sort of reverse pliers that whould clamp on the inside of the piston.............if i am right where would i get something like this?
oh and is it an easy enough job to replace the seals or is it a right git