09-10-11, 07:02 PM
My LHS rubber bit on the inside came out once, it's just held in with some brown glue. I assume if you give it a good pull and twist it will come out, then just use some grip glue or similar to put it back in place?
|
bar end question
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
bar end question - by serberusno1 - 09-10-11, 05:21 PM
Re: bar end question - by Andrew - 09-10-11, 07:02 PM
Re: bar end question - by serberusno1 - 09-10-11, 09:19 PM
Re: bar end question - by serberusno1 - 10-10-11, 06:49 PM
Re: bar end question - by DanielT - 19-09-12, 07:35 PM
Re: bar end question - by DryRob - 20-09-12, 12:11 AM
Re: Re: bar end question - by DanielT - 20-09-12, 12:41 AM
Re: bar end question - by DryRob - 20-09-12, 01:03 AM
Re: bar end question - by budgiemurray - 20-09-12, 10:10 AM
Re: Re: bar end question - by DanielT - 20-09-12, 02:47 PM
Re: bar end question - by Lazarus - 20-09-12, 02:55 PM
Re: bar end question - by budgiemurray - 20-09-12, 03:04 PM
Re: bar end question - by DanielT - 20-09-12, 08:11 PM
|
Users browsing this thread: 1 Guest(s)