[size=1em]Hi Guys, [/size]
[size=1em] My bike is a Fazer 600 99 plate, unsure on the mileage on the engine but the bike has done 49,600 miles[/size]
[size=1em]I've read tonnes and tonnes of posts for several weeks now, (even the whole 43 pages of Red98's which I thoroughly enjoyed...) but nothing is quite like mine, so here it goes  [/size]
When accelerating hard from "0 to 100 real quick" the bike pulls perfectly, until I get to 101mph (in 3rd) and then I hit an imaginary brick wall... :wall [size=1em]But its not like I shunt forward or anything, its like i've ran out of power. If I hold the throttle wide open it will eventually pick up speed, but it would take atleast 30 seconds to get to 110mph. When this almighty wall has hit me, the whole bike feels like it is out of sync, almost like a Harley [/size] :rollin and it also sounds similar to a vtwin apparently (mate on a zx10r rode next to me so I could show him).
[size=1em]When the bike is hot it is around 85-90mph when I am greeted with this wall, and it doesn't matter what gear I am in...[/size]
[size=1em]I replaced the engine for a known working one (roughly between 20,000-25,000, due to the whole engine overheating and also loosing the second gear... and the issue is still there :\ [/size]
[size=1em]The Carbs are clean and run perfectly and t[/size] he Coils have the correct ohmage.
Please help  Im loosing the plot haha
[size=1em]Ofcourse this is all done on private roads, and this isn't a big deal... but it would be nice to know what's happening and I was hoping to get onto Brands Hatch on the 26th [/size] :o
Any help would be appreciated :thumbup
Thanks,
Tom
We're the carbs changed as well?
Air filter okay?
How long have you had the bike?
Is it possible that it was previously restricted?
Has it ever gone over 110mph?
More people are born because of alcohol than will ever die from it.
(07-08-15, 01:28 PM)darrsi link Wrote: We're the carbs changed as well?
Air filter okay?
How long have you had the bike?
Is it possible that it was previously restricted?
Has it ever gone over 110mph?
Hi Darrsi,
The carbs are the original, they were cleaned around about 6 months ago.
The Air filter is good, KandN, had it since i owned the bike 3 years ago, was cleaned about 2000 miles ago.
I sold the bike to a good mate on 33bhp restrictions, so we put the plates in, and then brought it back off him around about a month ago. I was sitting around for 8 months, and he had only done around 3000 miles on the bike.
Yes, I have had 155mph out of it before selling it to my mate.
Thanks,
Tom
Sure it's not the Rev limiter?? Never tried mine that hard 
Maybe I should!!
Have you taken the plates back out? :lol
(07-08-15, 04:49 PM)JoeRock link Wrote: Have you taken the plates back out? :lol Or even tried changing up from 3rd :lol
Those are my principles...if you don't like them I have others.
(07-08-15, 01:53 PM)IamEEKY link Wrote: Yes, I have had 155mph out of it before selling it to my mate.
:rolleyes :rolleyes :rolleyes :rolleyes :rolleyes
Sounds like it's restricted. There's two types of restrictor,the after market washers and the Yamaha restriction through the carbs
Cleaning the carbs is one thing, having them balanced can help "a lot" although i doubt that's the main problem.
Don't rely too much on the filter being spotless, we've had some odd weather this year, mainly the tail end of other countries sand storms, i know this 'cos my K&N was noticeably dirty after 700 miles.
It does kind of hint at some sort of restriction by the sound of things, from earlier posts on here that sounds like a similar speed where the engine tends to run out of puff.
Have you ever noticed any hissing when opening the petrol tank cap, there'sa small possibility the tank breather could be blocked causing a fuel restriction?
If you really had 155mph out of it before then congratulations, 'cos you once had the fastest FZS600 in the country!
More people are born because of alcohol than will ever die from it.
155?
Pah I say!
And pah again!
Besides that, clearly you know about engines and are experiencing a problem, but I wouldn't expect it to get any faster in 3rd!
Some say...
(07-08-15, 03:53 PM)clayt74 link Wrote: Sure it's not the Rev limiter?? Never tried mine that hard 
Maybe I should!! 
I wasn't aware that they had a rev limiter :S
(07-08-15, 04:49 PM)JoeRock link Wrote: Have you taken the plates back out? :lol
100% there are no plates in there :lol
(07-08-15, 05:18 PM)Frosties link Wrote: [quote author=JoeRock link=topic=17875.msg206529#msg206529 date=1438962552]
Have you taken the plates back out? :lol Or even tried changing up from 3rd :lol
[/quote]
Any gear after 3rd it does it, but it is near enough at 100 every time so I can put it in 6 th and go from 30 to 100 no problem, today when it was happening I pulled the clutch and reved and it was still sounding like it was dying and I was unable to redline until my speed dropped... (07-08-15, 11:27 PM)His Dudeness link Wrote: Sounds like it's restricted. There's two types of restrictor,the after market washers and the Yamaha restriction through the carbs The carbs were never restricted, and I restricted it with the plates for my mate myself.
(08-08-15, 07:19 AM)darrsi link Wrote: Cleaning the carbs is one thing, having them balanced can help "a lot" although i doubt that's the main problem.
Don't rely too much on the filter being spotless, we've had some odd weather this year, mainly the tail end of other countries sand storms, i know this 'cos my K&N was noticeably dirty after 700 miles.
It does kind of hint at some sort of restriction by the sound of things, from earlier posts on here that sounds like a similar speed where the engine tends to run out of puff.
Have you ever noticed any hissing when opening the petrol tank cap, there'sa small possibility the tank breather could be blocked causing a fuel restriction?
If you really had 155mph out of it before then congratulations, 'cos you once had the fastest FZS600 in the country!  The carbs are balenced, and the the bottom end is amazing, a zx10r struggles to keep up round roundabouts/twisteys ... Until around 60... Haha :L
I'll take the filter out and give it a clean then  see what happens
And the tank pressure is good, I checked when I saw that in red98s post :lol
And thanks haha obviously that's was clock speed rather than gps :\
(08-08-15, 08:28 AM)Punkstig link Wrote: 155?
Pah I say!
And pah again!
Besides that, clearly you know about engines and are experiencing a problem, but I wouldn't expect it to get any faster in 3rd!
Clock speed  and it did take a while to get there but it used to pull to 140 and then slowly build up speed  but it really helps with a lower faring and being 10 stone :b
And she wants to go slightly more in third but "runs out of puff"
Soured for the long post but thanks for your help so far guys
Thanks,
Tom
Just an update guys, I replaced the rectifier, and that didn't help so now I am thinking fuel...
Thanks,
Tom
Kinked fuel line.
Blocked fuel filter.
Fuel tap switched fully on?
More people are born because of alcohol than will ever die from it.
(10-08-15, 01:18 PM)darrsi link Wrote: Kinked fuel line.
Blocked fuel filter.
Fuel tap switched fully on?
Nope,
Will see what state the fuel filter is later on today when I get home from work
And definitely :lol
10-08-15, 05:16 PM
(This post was last modified: 10-08-15, 05:19 PM by Frosties.)
Are the plug caps making a good contact to give a good spark...coils and plugs good?
It sounds like already mentioned - fuel starvation, air filter, blocked carbs etc. or you're a real fat bastid buuut apparently only 10 stone :lol
Weird one :book
Those are my principles...if you don't like them I have others.
You're certain its not restricted with the Yamaha restrictors
http://i.imgur.com/MXYe06W.jpg
If I remember correctly the Yamaha restrictor used different springs and needles and possibly slides as shown in the photo. If only the plates are removed although additional air getting through carbs the additional fuel isn't being picked up hence the problem if only the plates have been removed. The bike will be running incredibly lean
[size=1em] :'( I wrote a long reply this morning but it didnt post and now I cant remember what I wrote :rolleyes :rolleyes :rolleyes [/size]
(10-08-15, 05:16 PM)Frosties link Wrote: [size=1em]
Are the plug caps making a good contact to give a good spark...coils and plugs good?
It sounds like already mentioned - fuel starvation, air filter, blocked carbs etc. or you're a real fat bastid buuut apparently only 10 stone :lol
Weird one :book
[/size]
[size=1em]From what I can tell the spark plugs caps and coils are good[/size]
(10-08-15, 01:27 PM)IamEEKY link Wrote: [quote author=darrsi link=topic=17875.msg206764#msg206764 date=1439209117]
Kinked fuel line.
Blocked fuel filter.
Fuel tap switched fully on?
Nope,
Will see what state the fuel filter is later on today when I get home from work
And definitely :lol
[/quote]
I took the fuel filter out and it was quite dirty... :\ so i blasted it out, and i have ordered a new one should be here Thursday/Friday
I noticed that the fuel pump wasn't "clicking" when the tank was off, so I took it apart, all looked ok, hooked up to the battery and it spewed out some fuel with tiny bits of debris ??rust??cleaned and then noticed that the wire connector was very "used" so it's taped up for now :lol
I brought a KandN Recharge kit, cleaned and oiled the air filter  all nice and red :b
This morning i made some progress  it made it to 110 before dying, so i must be on the right track? :rollin
(11-08-15, 08:28 AM)His Dudeness link Wrote: You're certain its not restricted with the Yamaha restrictors
http://i.imgur.com/MXYe06W.jpg
Oh wow, that's cool, I never knew about them :eek But i'm 100% sure I didnt see anything like them in the carbs when they were cleaned
Thanks,
Tom
Are you sure you have standard gearing on the sprockets!! Sounds to me like you are expecting too much from the bike? Mine is standard and in 3rd (on a private road) I just top 100mph at 13krpm (just into the red) and I wouldn't wanna push it beyond that plus you are way beyond the max torque point so pretty pointless??
If you had different gearing it would explain your higher speeds but would also explain the additional loading that would cause your overheating problem?
Thinking about it - this sounds exactly the same as what mine was doing when the spark plug caps were breaking up (although mine was happenening at around 80 odd. Might be worth replacing them (there's a red NGK set people use that work perfectly) - not very expensive from what I remember?
|