Odd question: Seeking exact measurements/template for speedo surround

[helloindustries]

I made and tested my template today with basic paper. Perfect fit first time.

See here.

[MC680x0]

:thumbup
Just as I did and my recommended method . Easy! Well done

[helloindustries]

What i actually did was:

1. Find image of a pre-made version (likely wrong)
   
2. Measured parts on bike
   
3. Adjusted template to match
   

[MC680x0]

Not what I recommended then. But if it works ..

[unfazed]

I have a set which I would swap for your creation when you have them completed.

[helloindustries]

I have a set which I would swap for your creation when you have them completed.

A set of what?

The template is shared a couple of posts up, so if you'd like to make a surround, all you have to do is print it on the back of whatever material you're using, assuming it'll go through a printer...

[unfazed]

The front gold part in carbon (Took it off because I didn't like it) and the clock inners. A Set of 4 items  :lol

[helloindustries]

The front gold part in carbon (Took it off because I didn't like it) and the clock inners. A Set of 4 items  :lol

Ahh cool.

Would you be willing to scan the clock liners for me, please? I'll also need each one measuring so i can get designs to be super-acurate.
I'll happily share my work here when done.

[unfazed]

No problem, they are from the foxeye model.

[unfazed]

Pm me your address and I will post them to you, the you will have exact measurements. Post them back to me when you are finished.

[helloindustries]

Pm me your address and I will post them to you, the you will have exact measurements. Post them back to me when you are finished.

That's incredibly nice of you! One PM incoming!