05-01-22, 08:40 PM (This post was last modified: 05-01-22, 08:55 PM by beuleux.)
Hi all
On my 08 FZ1 there are some blanked plugs in the wiring loom under the left had trim cover and one with no female end, does anyone know what they're for? The bike was like that when I got it with no issues as yet, I found some bodge wiring for heated grips which I removed. If nothing else I'd like to satisfy my curiosity
Thanks ?
*oops just realised should have posted this is fazer corner.. doh!
*Disclaimer*
Nothing I say should in any way be taken as a good idea ?
(07-01-22, 09:45 AM)Gnasher link Wrote: They look like ABS system to me, is your bike non ABS?
No it has ABS and it still works, although the dash light did come on when I first restarted it after changing the front pads, not sure if that means anything, I took it for a 40min spin with no issues.
I'm more concerned about the male end that goes nowhere. The others seem factory blanked for whatever reason.
*Disclaimer*
Nothing I say should in any way be taken as a good idea ?
It's been a while since I've poke around with FZ1 wiring and it's wasn't a regular occurrence either. The only other thing I can think of off the top of my head is 'immobilizer' circuit, some counties had them as standard fitment.
Looms are wired to take it, although the unit isn't fitted.
If your that interested, get a wiring diagram out and trace the wiring colours
(14-07-22, 09:15 AM)b1k3rdude link Wrote: hmm, connection for the yahama immobilisor perhaps..
Got a wide angle shot of where these connectors are on the bike..?
They are in the fairing loom connector bundle left hand side under the fairing inner cover. Quite possibly an immobiliser but I thought it already came factory wired, I have since discovered the four plug one is for yamaha diagnostic tool. Next time I have an excuse to take the fairing inners out I will take a wider angle pic and maybe put the matter to bed to satisfy my pedantic curiosity.
*Disclaimer*
Nothing I say should in any way be taken as a good idea ?
