FZS600 lights not working

[Stogie777]

Hello,


I’ve got a problem with my 2001 boxeye. Seems to be very similar to some other issues on here but they were on a fox eye and fixed by replacing a relay that doesn’t exist in the boxeye.


Essentially with lights switches on side or dipped, full beam on or off I get no lights at all. If I pull the flash trigger one side does come on. All brake lights and indicators function normally.


I’ve taken apart the right switch gear and all contacts look clean.


Any ideas?

[Gnasher]

It's more than likely an earthing issue, either within the switch or in one of the connecting plugs/blocks.  Put a tester on the circuit check for continuity. 

[BBROWN1664]

:agree

Look at the cable from the light switch and check its all plugged in properly under the tank.

[TOM VR46]

One wee idea as this happened to me before. Check ignition wires. I went all through wires, connectors , switches but not ignition switch. Someone said put key in , switch on and headlight switch on, and gently move wires at the bottom of ignition, even steer left to right a few times and see if they come on. They did. I had broken wire in the ignition. And if theres a problem with it, theres a post somewhere on here to take it apart.

[Stogie777]

Thanks for your help gentlemen.


Traced the cabling inside the nest of rat’s tails under the tank and found a very burnt out connector. Promptly rewired it, a bit fiddly due to cable length but got it sorted.


Cheers

[Gnasher]

:thumbup