Is the 2008/9 r6 shock mod for early fazer 6 as well?

[Tubz1983]

Seen a few posts on here about replacing the standard rear shock with a 2008/9 r6 unit, but I'm unsure if it only applies to the fazer 1000 ? Thanks

[Boris]

Yes it does. As the end of the FZ6 shock that connects to the swingarm is a different design to those R6 aftermarket ones used on Fazer Gen 1's.

[risticuss]

Now don't quote me on this,  but the 98-01 r6 shock has a similar mounting configuration so 'might' fit.

Quite cheap on eBay too so could be worth a punt, or a bit of research into the sizes/measurements.

[kebab19]

I believe the FZ6 has no shock linkage mechanism - it's attached directly to the swingarm?
If so, then at the very least the spring would need to be much heavier - twice the rate of something like an R1.  Furthermore, the internal valving will also be off. 
You may however be able to get away with just a spring change.