wanted : FZ1 mirror thread caps..

[Mike01]

Hi.
Using end bar mirrors on my naked FZ, need the caps for the OE threads, bike is 2007.
Cheers.

[slappy]

Try ebay

[Mike01]

Try ebay

I did, only ones I found for the FZ are £12.50... Would rather wait.

[noggythenog]

Is it an FZ1 or an FZS600 Mike?

[Mike01]

Is it an FZ1 or an FZS600 Mike?

It's for the Fz1, was going to get mirrors back on there but finding the end bar ones that were on it when I picked it up yesterday very good 

[noggythenog]

[quote author=noggythenog link=topic=17280.msg199156#msg199156 date=1434051119]
Is it an FZ1 or an FZS600 Mike?

It's for the Fz1, was going to get mirrors back on there but finding the end bar ones that were on it when I picked it up yesterday very good 
[/quote]


Ah no probs, just looked at your profile said 600 & i mighta had 600 caps somewhere in the shed.

[Mike01]

[quote author=Mike01 link=topic=17280.msg199157#msg199157 date=1434051296]
[quote author=noggythenog link=topic=17280.msg199156#msg199156 date=1434051119]
Is it an FZ1 or an FZS600 Mike?

It's for the Fz1, was going to get mirrors back on there but finding the end bar ones that were on it when I picked it up yesterday very good 
[/quote]


Ah no probs, just looked at your profile said 600 & i mighta had 600 caps somewhere in the shed.
[/quote]

Cool, thanks anyway mate.

[farmer giles]

I used something like this to block up the holes on my FZ8 after I fitted bar end mirrors..

http://www.ebay.co.uk/itm/Plastic-Black-...487f9329bc

Just have a measure up and get the size and quantity you need..  I had to trim the 'threaded' part down a little but they've been in over a year with no problem..

probably only be a couple of quid with a couple of spares if you cock one up trimming it down..

HTH

edit..

just found a pic..

[Mike01]

I used something like this to block up the holes on my FZ8 after I fitted bar end mirrors..

http://www.ebay.co.uk/itm/Plastic-Black-...487f9329bc

Just have a measure up and get the size you need..  I had to trim the 'threaded' part down a little but they've been in over a year with no problem..

HTH

edit..

just found a pic..

Looks perfect, will double check but think the 10 mm should do it 
Thanks for that mate.

[farmer giles]

no probs..

there are loads of different versions on ebay.

When I looked for mine I tried the match the diameter of the head to the fitting and then just trimmed down the 'threaded' part to fit the hole..

hope you find the right size.