|
fzs600 sprocket cover
|
21-09-15, 09:04 PM
The steel plate on the rear of the cover is it to save the case in the event of a chain flying off or is there another purpose?
Modifying cover to reverse the shift pattern and need to know if I can just remove it
Complete fabrication, I didn't make it up!
21-09-15, 09:18 PM
(This post was last modified: 21-09-15, 09:22 PM by fazersharp.)
(21-09-15, 09:04 PM)joebloggs link Wrote: The steel plate on the rear of the cover is it to save the case in the event of a chain flying off or is there another purpose? No you can not remove it --------------- no fecker can as the screws are made out of cheese I beleve that it is somthing to do with sound proofing / damping and was ditched in later models Do you mean this with "X" on it and 4 (cheese ) screws
I don't do rain or threat there of. dry rider only with no shame.
21-09-15, 09:49 PM
Lol
You read my mind Its getting attacked with 4 inch grinder tomorrow Focer will come off Thanks
Complete fabrication, I didn't make it up!
21-09-15, 10:13 PM
(21-09-15, 09:49 PM)joebloggs link Wrote: Its getting attacked with 4 inch grinder tomorrow I would of said 10inch but hey --- its your choice
I don't do rain or threat there of. dry rider only with no shame.
22-09-15, 02:00 AM
Only want to take the head's of the screws not cut it in half lol
Complete fabrication, I didn't make it up!
|
|
« Next Oldest | Next Newest »
|
