RPM Signal

[Dan.C.]

Hello!
Suddenly my old gauges stopped showing me the revs. No problem, cause the new speedometer just arrived.
But, after the install of the new speedo, everithing works just fine, except the revs!
I tried to follow the yellow/black wire and see where it goes but it's a pain. I'll end up striping the entire electrical on my bike.
Can you tell me where I can get RPM Signal and just ignore the factory yellow/black cable?

A few photos of my "Cafe/Fighter" Fazer. Still a lot to be done...

[clayt74]

Dude...... Please tell me that that custom pipe is not blowing oily gases all over ya rear tyre!!!
Looks sweet but not sure I would ride it?!?!

[Dan.C.]

It is pointing to the right side of the bike It's blowing on my right leg 

[Lumpy]

oily gases? Mine doesn't blow oily gases 

[Hawko]

Hello Matey


Was searching through posts, and as I bought same speedo as you have shown here, was wondering if you ever got the RPM sorted, as thats one area that isnt working on mine as well?


many thanks

[jackw96]

When my speedo drive went bad, the speed constantly read 0 and the revs would work intermittently. Would definitely look into that.

[Hawko]

When my speedo drive went bad, the speed constantly read 0 and the revs would work intermittently. Would definitely look into that.

Ok thanks neither are working at the moment will check,the speedo coupling on the front wheel


Cheers