R6 Rear Shock

[PeeGee]

I have just replaced my old standard rear shock with an R6 unit supplied from Kebab19. It has been one of the easiest mods I have done, remember to fully clean and check over the suspension linkage, mind all the roller bearings, re grease and replace any worn bearings. I would say the entire job took no longer than 2 hours. All as I need now is more bend on my knee as I have had a full replacement joint, maybe this will save on a knee slider as I am reliably informed it is titanium. :rollin 

[Beeblebrox2nd]

I'm liking this a fair bit.
May I ask as to what model R6 the shock came from or does that not matter?

[rhinoeli]

It is the RJ15 model, 2008+

[stevie-g1968]

does it have to be that model, or will the early model shocks fit ?

[kebab19]

There's a thread not so very far down the page detailing what shock is required. Nothing pre 2005 will fit, that's for sure and unlikely that 2006-07 shock can fit easily. 

... and not long now till I reveal my next FZS suspension mod 

[rhinoeli]

... and not long now till I reveal my next FZS suspension mod 

Is it for the front or rear? 600 or thou?

[kebab19]

For the 600 ... front this time 

[Nebuchernezzer]

Does this mean i should wait and see what it is before i dive into my 600 front end?

[kebab19]

No, go ahead - it won't be a cheap mod.
But it will be one of the best 

[mtread]

I'm guessing USD forks  If so, can't wait to see.

[Nebuchernezzer]

Haha all good then, i'm too stingy for expensive mods!

[Znd93rus]

looks great! 
What do you have in front end?


How does Fazer run with such beautifull shock?[size=78%] [/size]

[midden]

looks great! 
What do you have in front end?


How does Fazer run with such beautifull shock?[size=78%] [/size]

it runs very nicely

[kebab19]

I'm guessing USD forks  If so, can't wait to see.

Ummm... actually, no USDs this time round :eek
Perhaps I have underestimated the overwhelming desire for gold, blingy things attached to the front of bikes  :lol

[Znd93rus]

Kebab19 and other guys, please tell me if the shock on photos is just right unit.

[Nebuchernezzer]

I believe the two adjusters, Gold and blue,  should be together. Look at the photo at the top of the page. But I'd also away the more knowledgeable to chime in.

[Znd93rus]

Thanks, Nebuchernezzer.