Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Fuel gauge problem
#1
Anyone know a quick fix for this? Filled her up, gauge went to full, after 100 miles gauge still showed full - funny, i thought. After 175 miles warning light flickers on (hmm, that still works then). Needle goes up & down when I turn on & off but when powers on stays permanently up (dream on misses). It's not an essential fix but it is a bit annoying! Any ideas out there?
If it ain't broke.......just tinker with it a little anyway!
Reply
#2
you may have a short on the feed wire to the gauge,or a short in the sender unit
Reply
#3
I had that problem on mine the other week, just unplugged the electrical connector under the tank and plugged it back in and it all seem to work again!
Reply
#4
Don't know if it works on a float system, but check its not blocked up with crud in the tank maybe?

Red Heads - Slowly taking over the world!!!
Reply
#5
Thanks for the advice/suggestions guys. Hopefully the 'unplug and plug back in' will do the job. I don't mind hammers and spanners but usually end up getting my wires crossed with electrics! :o  Hope to have time this weekend between buying a tree, wrapping presents, cleaning bike and car, prepping car for MOT (what a stupid time of year for an MOT) and ferrying kids around Gloucestershire.
If it ain't broke.......just tinker with it a little anyway!
Reply


Forum Jump:


Users browsing this thread: