hi guys, Gals, im new today to the forum. Got a 600 fazer and love it. 1999. any issues with them

[color=rgb(0, 0, 0)]Hello,[/color]

[color=rgb(0, 0, 0)]So looks like my speedo cable has been routed incorrectly and I found it being sliced in half by one of the front discs. Does anyone know it the cable is its own part that I can replace or does it belong to the (expensive) sensor assembly?[/color]

[color=rgb(0, 0, 0)]2002 FZS600[/color]

[color=rgb(0, 0, 0)]Many thanks....[/color]

just got the bike out this morning  after a while, think it was end of jan i was last on it & was working fine, not now though  :'( so what do you think  ,solenoid or starter?





https://www.youtube.com/watch?v=M34l2V84...e=youtu.be

Having sold most of the 2003 Gen1 that I was breaking I'm now left with the Engine and Frame which will also come with it's numbers matching V5.
So I'm selling it off as one lump for what I think is a pretty cheap price as I would just like it out of my way now. Engine had around 43K on it and ran fine prior to the bike being stripped.

All details can be found here as I'm now having trouble loading pictures to the website. https://www.ebay.co.uk/itm/143556031812
I'm looking for £150 for the lot with collection from me in Worthing, West Sussex.

[size=1em]Two of the exhaust studs have broken on the 2004 FZ6 I recently purchased  :'( .  Yes I guessed they had never been undone since new and yes I should have cut, or tried to cut, the nuts before I broke the studs, but I didn't.[/size]

[size=1em]Today I've tried adding another nut and welding it on with my Aldi Arc welder.  I got a fair weld but the stud sheared again just under where I welded it and I've now got a little less left than shown on the picture (link) below.  No signs of movement (with the exception of one that came out with the nut) and I don't think I'm getting enough heat into it.  [/size]

[size=1em]A friend is coming around on Saturday with his Mig who has successfully extracted a couple before using this technique, but I'm not too hopeful (and somewhat crapping it in case I end up having to take the head off  :\ ).[/size]

[size=1em]I'm thinking the best thing might be to cut and weld some threaded bar onto what I've got left and grind it down with a dremel.[/size]

[size=1em]Anyone got any (non depressing) thoughts?[/size]

[size=1em]https://photos.app.goo.gl/i3HjTDmNUxJAeBBk8[/size]

I have a brand new set of CR9E plugs, £17 posted

any one have  a set they want to sell ????

hi guys
any one were to get the yam logo frame plugs from ????
thanks
mike

looking for a low seat that will fit the 2010 FZ6 S2 around about 1" lower

I bought this R6 rear damper to fit my 2002 fazer 1000, but i never got round to fitting it, i dont have the dogbones, i sold those earlier.
Any one interested in the damper