Number plate mod

[Loz]

I would like to get a slightly small number plate but it looks like it might look a bit naff on the original under tray unit, has anyone cut their undertray down and if so can it be done neatly and what did you use to do it ? 

[ghostbiker]

Trimed mine with a dermal but a hack saw would have been better as the dermal melted it rather than cut it. So then needed to go over it to clean it up.

 I didn't trim mine a huge amount but I have seen others hack it back a long way.

2 words or caution, 1 you need a reflector so do as I did and leave the old one in place on its tab or as others do and stick a stick on one on the plate itself.
2 even cut back a little and you get a LOT more spray up the back. I meen a LOT :P

Will try to find a pic of it.

[ghostbiker]

[Ian-man]

I cut mine back to just shorter than the number plate and stuck the reflector under the light where is says yamaha with double sided sticky  tape.

[GrahamB]

Trimmed mine with combination of sharp knife & cutting disc on grinder. Had to heat the housing where my indicators now bolt to get them straight & remount the reflector but I think it was worth the effort. Marked it with masking tape before cutting to be sure I liked the lines.

[seangee]

[Loz]

Thanks for all the tips and pics, they have been really helpful, going to order the plate tonight and then get cutting