HI All, today i tried to renew my clutch but since putting it all back together and starting up, my clutch does not seem to engage at all.
I followed this video
basically, I drained my oil, removed oil filter and fitted new oil filter. Then took clutch cover off, removed clutch springs, pulled off old pates and put in my new (soaked in oil plates). Followed the video, starting with one friction plate, then steel plate, then judder spring, then the friction plate, steel plate until all on the basket. Replaced springs with new ebc uprated ones, tightened it all up. new gasket, put clutch cover back on, Put new oil in and started it up on centre stand. With the clutch lever pulled in, in first gear the back wheel was spinning. Used a bit of throttle and pulled clutch lever in at same time, nothing happened. Put bike off the stand, slowly let the clutch lever out in first gear, nothing, the bike did not react.
I have tried the clutch lever adjustment screw both ways to max/min with no change. Also tried the screw and lock nut under the rubber cover on sprocket case, still nothing. There is good tension in the cable when clutch lever pulled in, i.e. it feels like the cable travels as it used to.
Any help or advise on what I may have done wrong or should check?