Since i did this way back when i thought i'd revisit it now that many R1's models have since been and gone
As usal i want it to look as factory as possable
1st stage was the fitment and sorting of spacers and disc's to fit the later r1 5 spoke wheels
![](https://fbcdn-sphotos-a.akamaihd.net/hphotos-ak-ash4/393639_10150400838128800_682288799_8788256_1604842748_n.jpg)
So shopping list was then put in place and ebay put to good use
A set gen 2 yokes were sourced
![](https://lh3.googleusercontent.com/-ES-Y7G1HGC8/TxgC4ppktEI/AAAAAAAACkY/YJapu0yoUr0/s720/17062011028.jpg)
Now the fazer stem was swapped out but was 1mm to small into bottom yoke so the stem was turned down to - 3mm and
a top hat made +4mm and welded in place this did away with the need to pin
gen 2 yokes also retained the factory look i was after rather than a after market r1 top yoke or a rewoked r1 top yoke
Now it is well know i personally dont like the lines of the gen 1 when not correcting the fork length i just dont like the
stance
so a set extenders were made and capped off with my frame plugs
![](https://fbcdn-sphotos-a.akamaihd.net/hphotos-ak-snc7/404452_10150505933838800_682288799_9204444_1254221122_n.jpg)
![](https://fbcdn-sphotos-a.akamaihd.net/hphotos-ak-ash4/396648_10150505936463800_682288799_9204446_562954948_n.jpg)
![](https://fbcdn-sphotos-a.akamaihd.net/hphotos-ak-snc7/409477_10150507655528800_682288799_9208842_2061128023_n.jpg)
these will give me back the lost length on the 08 legs and still if i require allow me to drop the front up to 10mm
this also overcomes the sidestand issue
std dics on the 08 are 298 and i can use the r6 ones already fitted but i have some 320mm from the 04-06
i am going to use along with the six pot calipers
![](https://fbcdn-sphotos-a.akamaihd.net/hphotos-ak-ash4/397312_10150507676058800_682288799_9208861_166369932_n.jpg)
i'll keep the thread updated as i progress with this