FZS 600 Issue

[tgordine]

Hello everyone, I'm new to the worl of owning a fazer and also to this forum so firstly just wanted to say hello to everyone but also at the same time I have an issue with my fazer I was hoping you guys could help with.


Pas I have only recently got a fazer I was taking a look at a few bits today but I seem to have dislodged some hoses and can't for the life of me see where they connect to. I can see that they both go into the carbs and that end is still connected, this picture shows them quite well;





It's the 2 hoses at the bottom of the picture one is shorter than the other but does anybody know where the other end of this connects. Many thanks for any help.

[hightower]

It's heater system inlet and outlet. Have a look at manual, (downloads section), book 4 fuel, chapter 7.9

[Fazerider]

The heater circuit connections both point upwards.
Those are the overflow hoses and tuck down behind the engine to dump exceed fuel on the road should a needle valve go leaky.

[unfazed]

The heater circuit connections both point upwards.
Those are the overflow hoses and tuck down behind the engine to dump exceed fuel on the road should a needle valve go leaky.

 

[tgordine]

Thanks for the info guys, I thought I was going insane as I couldn't see anywhere they would have become disconnected. Is there a correct routing for these hoses or is it just a case of pointing them at the floor and don't worry about it?

[unfazed]

Yes, on the back right hand side of the engine there is a guide for the two hoses

[red98]

through the guide as above and between the engine and swing arm....its a bit tight but doable