+- Fazer Owners Club - Unofficial (https://foc-u.co.uk/mybb)
+-- Forum: Bikes, Hints'n'Tips (https://foc-u.co.uk/mybb/forumdisplay.php?fid=66)
+--- Forum: Fazer 1000/FZ1 corner (https://foc-u.co.uk/mybb/forumdisplay.php?fid=75)
+--- Thread: Gen 2 wobbly mirror (/showthread.php?tid=80297)
Gen 2 wobbly mirror - malc - 05-12-18
Anyone got a cure, my right mirror is a bit wobbly, it's from the base of the stem where it has a large pin under the plastic cover, if i fold the mirror it's not wobbly, wondered if anyone has had the same issue and if there's a way to pack it out somehow ?
.
Re: Gen 2 wobbly mirror - b1k3rdude - 05-12-18
Got a picture of it, as I have some patter gen 1 mirrors..
Re: Gen 2 wobbly mirror - mw2018 - 19-12-18
my left one wobbles a bit, i took it off and looked underneath it but it's kind of pressed together with nothing you can adjust or tighten up. so i put up with it, think of it as character. 8)
Re: Gen 2 wobbly mirror - NorthWestern - 20-12-18
My first gen 1 had this issue. I drilled out the rivet, the spring washers had corroded inside the hinge so I ordered new springs off ebay (about 60p). While I waited for delivery I built it back up with a washer to compensate for the missing springs which was OK but couldn't be folded back properly... You could just bolt it up solid.
Re: Gen 2 wobbly mirror - FZ1obp - 20-12-18
I've had this a few times on my 2009 Gen 2:
Unbolt the mirror and remove the boot, take two sockets and place one each side of the thin tube that's holding the mirror assembly together and gently apply pressure in a vice to the sockets so that the tube is lightly compressed (ie the sockets need to be sized so that are bearing on the rim of the tube).
Might take a couple of goes
Then re-assemble and check it's wobble free. If not repeat.
Hope it works
Re: Gen 2 wobbly mirror - malc - 30-12-18
Thanks for the replies, it's not too bad at the moment but when I next have the fairing lowers off (need to be off to get the inner out) then I'll try the 2 sockets and press.
.