+- Fazer Owners Club - Unofficial (https://foc-u.co.uk/mybb)
+-- Forum: Bikes, Hints'n'Tips (https://foc-u.co.uk/mybb/forumdisplay.php?fid=66)
+--- Forum: Fazer 1000/FZ1 corner (https://foc-u.co.uk/mybb/forumdisplay.php?fid=75)
+--- Thread: multigauge question (/showthread.php?tid=78996)
multigauge question - Woodzey80 - 05-11-17
Has anyone with the gauge fitted the extra 3rd button for changing between view modes ? If so how do you fit it in laymans terms !?! Thanks
Re: multigauge question - reggit - 07-11-17
Can’t help yet, but I’ll watch with interest!
I was going to have a play with that wire over winter to see if it was worth connecting.
Re: multigauge question - blackcabbie - 08-11-17
its all on christians multiguage website....... the 3rd button switches 12v onto the outside temperature sensor wire via a resistor and a diode that are soldered onto that wire...... i think i already did this on the guage i sold you ..... the cct diagram for this is somewhere on christians website...
cheers
Re: multigauge question - Woodzey80 - 08-11-17
The separate circuit board you supplied was for connecting up the fuel calculation feature to the gauge. As for the 3rd button mod you had spliced a wire onto the external temperature sensor but this was just bare & going to nothing. Christians site does show the wiring diagram (with additional resistor & diode) for the 3rd button but does not show where the button fits into the circuit.
Re: multigauge question - blackcabbie - 08-11-17
the bare wire goes to one side of black push button and the other side of button goes to 12v