![]() |
54 plate Fazer cutting out... - Printable Version +- Fazer Owners Club - Unofficial (https://foc-u.co.uk/mybb) +-- Forum: Bikes, Hints'n'Tips (https://foc-u.co.uk/mybb/forumdisplay.php?fid=66) +--- Forum: FZ6 / Fazer (https://foc-u.co.uk/mybb/forumdisplay.php?fid=77) +--- Thread: 54 plate Fazer cutting out... (/showthread.php?tid=78451) |
54 plate Fazer cutting out... - JimMcDonnell - 13-07-17 Hello all - first post, and of course it's a problem... My 54 FZ6, 56600mi, has been cutting out recently, at pretty much any speed. No coughing or stuttering, just running fine then nothing. I can sometimes drop down the gears while rolling and then 'bump' it going again, but more usually I coast to the side of the road and get nothing from the engine when I turn it over; after some time (eg when it's cooler?) it will start. Maybe. I thought it might be fuel; I know there's some gunk in the tank - but the bike stops completely, dead in the water. No rough running or spluttering as a warning. Got helped home by the AA last night, and they theorised it might be CKP sensor when the bike is running hot. Took a plug cap off and tested the spark - nothing until the bike has cooled. I put bike in diagnostic mode this morning, and did indeed get a '12' code - CKP. Sound plausible? Why would it get worse/occur when the bike is hot? Last night's cut-out happened within 3 miles of leaving home, not 'hot' by any standards, even in summer weather. I had to have a gearbox rebuild at xmas, and when I got it back I noticed (after a while) the the small bolt in the crankcase cover had been left off - so I was running the bike 50 miles a day in winter muck with a hole into the crankcase. Had that sorted when I got new rubber a couple of months ago, but - could that have caused a CKP problem? At no point have I had any warning lights or codes on my dash. Any suggestions gratefully received... Jim Re: 54 plate Fazer cutting out... - Grahamm - 13-07-17 I had a similar issue that turned out to be a dodgy kill switch. Get a multimeter and check the kill switch, side stand switch, tip-over sensor etc for good continuity before you start looking for anything more complicated. Re: 54 plate Fazer cutting out... - slappy - 14-07-17 Do you have another ignition key ? If you have try it as sometimes the key is worn and loose in the ignition barrel and can cause the bike to cut out. |