![]() |
Bike wont tick over when cold fz1 2007 - Printable Version +- Fazer Owners Club - Unofficial (https://foc-u.co.uk/mybb) +-- Forum: Bikes, Hints'n'Tips (https://foc-u.co.uk/mybb/forumdisplay.php?fid=66) +--- Forum: Fazer 1000/FZ1 corner (https://foc-u.co.uk/mybb/forumdisplay.php?fid=75) +--- Thread: Bike wont tick over when cold fz1 2007 (/showthread.php?tid=72638) |
Bike wont tick over when cold fz1 2007 - davey boy - 24-05-15 Any help would be apreciated off touring the outer hebridees in a few weeeks so want to get it sorted I have fitted a fce and a power commander v and since then when i start the bike i have to hold the throttle open untill it warms up then it runs perfectly Could it be the o2 optimiser Any sugestions Re: Bike wont tick over when cold fz1 2007 - noggythenog - 24-05-15 I've got an FCE fitted & I also have a brand new PC5 which I haven't fitted yet. thing is I already have an intermittent starting problem doh!....so it will be a little while before I go fitting anything else until I establish what is at fault. Have you tried it with a different PC map to see if it is a dodgy map causing it or have you tried completely disconnecting the PC5? Re: Bike wont tick over when cold fz1 2007 - slappy - 24-05-15 When I fitted my FCE my tickover was affected, it would still tickover but had dropped to 950 revs and was lumpy. I adjusted it with the adjuster ( ! ) to 1050 revs and it was fine, I think manufacturers set it to 1100 / 1200. Re: Bike wont tick over when cold fz1 2007 - noggythenog - 24-05-15 & here's the adjuster.....turn with a screwdriver...jobs a good'n. Good shout slappy.....i was panicking there thinking i might get more issues after fitting my PC5. Let us knowhow you get on will ya Davey please. Re: Bike wont tick over when cold fz1 2007 - davey boy - 24-05-15 Thanks for the reply lads just got back home so will try in the morning I thought you could only ajust the tickover on bikes with carbs, you learn new things all the time:-) Re: Bike wont tick over when cold fz1 2007 - DekF - 24-05-15 The warmed engine temperature idle is best at 1250 - 1300. Any less & you risk temperamental starting & a lumpy tickover. The enriched idle for cold starts should be 1500 - 2000. Re: Bike wont tick over when cold fz1 2007 - davey boy - 25-05-15 Sorted thanks That was an easy fix although I could only get it to about 1100 rpm on the tachometer and the adjuster was spongey didn't want to push it invade I snapped it I soaked it with wd40 but that's as far as I can get Re: Bike wont tick over when cold fz1 2007 - slappy - 25-05-15 Yeah, there does not seem to be very much adjustment, I had my laptop hooked up to the bike through the Juicebox as it shows engine revs a lot more accurately, I would assume that you could the same with a pc5 or pc3. What Dekf says about the idle speed is more than likely right , he has a lot of experience in tuning the gen2 , but I just found my tickover was ok at 1050 revs and at 1100 or more the bike just sounded as the tickover was set too high. |