+- Fazer Owners Club - Unofficial (https://foc-u.co.uk/mybb)
+-- Forum: Bikes, Hints'n'Tips (https://foc-u.co.uk/mybb/forumdisplay.php?fid=66)
+--- Forum: Fazer 1000/FZ1 corner (https://foc-u.co.uk/mybb/forumdisplay.php?fid=75)
+--- Thread: Exup cable question (/showthread.php?tid=57989)
Exup cable question - solorider - 27-03-12
As some nice last owner disconnected the cables I have to replace them as they were frayed,so the question is does the top cable go to the top of the motor and top of the exup valve? Or do they cross over?
Re: Exup cable question - Falcon 269 - 27-03-12
I think the cables are numbered and there's corresponding numbers on the servo motor pulley.
You can get the orientation of the cables at the valve pulley from Pat's Site.
Re: Exup cable question - eddie - 27-03-12
colour coded
http://www.cartestsoftware.com/fz1/images/exupcableadjustingnuts1.jpg
Re: Exup cable question - solorider - 30-03-12
(27-03-12, 05:07 PM)eddie link Wrote:colour codedThe link you supplied did not work,but thanks for the info,in the end I got what I needed from the other fazer owners site http://fazer1000.yuku.com/topic/1524/EXUP-Valve-Maintenance#.T3ValhB5mSM ,it was lucky the owner did not remove the cables from the top as I would have been stuck
http://www.cartestsoftware.com/fz1/images/exupcableadjustingnuts1.jpg