Hello Gentlemen,
Can anyone tell me how the f--k do you get the front sprocket off my 02/03 fzs600. I purchased the new modified sprocket nut and washer from Yamaha and have tried a couple of times to undo the sprocket retaining nut, I think the Incredible Hulk fitted it originally. I am assuming it is a standard right hand thread. 32mm socket and a 500mm extension lever, I am frightened to apply any more force than I have thus far for fear of snapping something.
I have left it for now as I have rightly or wrongly reasoned that as its that tight it's not likely to cause a problem. I have read about all sorts of nasty things happening when problems occurred with the nut.
I am 12st 10lbs in weight and a retired bricky so I am not adversed to applying a little force, but have shivered at the thought of snapping or stripping a thread on the shaft. Am I just being a tart and should I go for it?
Advice welcome and I am aware that the ultimate decision rests with me.
Someone said put a gas torch on it but not going down that route as it seems to me to risky, firstly removing any hardening and tempering from the shaft itself and or screwing any oil seals in the vicinity.