Gave it a quick coat of paint just for the pictures, think powder coat will be best considering the battering with will get sat behind the wheel.
Its not perfect but not to bad for 1st attempt, if you look at the back near the light it's just below the line of the tailpiece, with the plate on it'll be difficult to spot and even then you'd need to be on your knee's to see it. The tapes only holding the rear in position as I haven't the right fasteners and they're a bit awkward to tighten up so left them off for now.
Lot of messing around just to cover up the dodgy cut down rear guard but hey
Fazersharp. When I drill my old plate I'll see where the bolt holes land and may re-drill the bracket if I'm not keen, will have to wait, beer o'clock
Above picture, bracket sitting low due to not being fastened